Analysis of the HamSCI Solar Eclipse High Frequency Time Difference of Arrival Experiment Observations Using Automated Techniques

The objective of our research is to use narrowband linear audio pulses, which are sensitive to time displacement, and transmit them through High Frequency (HF) commercial off-the-shelf (COTS) single-sideband (SSB) amateur radios to measure changes in ionospheric reflection heights, specifically during a solar eclipse. This will be accomplished and automated using programming techniques learned in the Digital Signal Processing course at the University of Scranton, where the primary objective is to use TDOA (Time Difference of Arrival), a technique that measures the time displacement of single/multiple paths as they reach a receiving station. These TDOA values will be manipulated using a virtual height model that will yield different values of ionospheric layer heights based on the locations of the receiving and transmitting stations. During the October 2023 and April 2024 solar eclipses, WA5FRF transmitted a series of linear audio pulses (chirps) every 10–15 minutes to various receiving stations on the 5, 7, and 14 MHz amateur radio bands. Received signals were squared and filtered to detect the waveform envelope. Correlation with a matched signal was then used to identify the start time of each chirp, after which a Fast Fourier Transform (FFT) was used to identify the beat-note frequency generated by multipath propagation. The October 2023 eclipse automated analysis shows that the F region reflection point was raised from 262.5 km at 17:00 UTC to 300 km at eclipse maximum at 17:30 UTC. The April 2024 eclipse analysis shows no real maximum reflection point; however, it does indicate an increase in layer height following maximum obscuration at 18:30 UTC. Both analyses are in good agreement with the hmf2 observations of the Austin Ionosonde. The intended purpose was to monitor multipath interference for 1–2 hops off of the F2 layer; however, recent developments in this automated process yield additional data for other modes.